Floor standing insulation stripper
 

Subject to technical alterations

This insulation stripper is designed for removing wound and enamelled insulation's on the connection ends of performed coils, armature bars, braided wires, equally whether they are of round or rectangular cross- section.

This machine has shown itself to be of particular advantage when stripping armature bars from defective windings: in this respect burning off and the corresponding danger is avoided whereby the remaining tin can become alloyed with the copper causing the bar to become brittle. Glass silk insulated wire can be perfectly stripped leaving the bar clean for soldering. The swarf is collected in a box avoiding possible hand irritation. The hand wheel allows adjustment for any required cross-section from about 1,0 mm upwards.

If required, we fit a reversing switch for the upper motor so that the brush rotation can be in either direction. With heavy cross-section the pull of the brushes is very strong, where the brushes rotate in opposite directions. By use of the reverse switch the pull is effectively eliminated.

Technical Data:

Floor standing insulation stripper with reserve switch and dust extraction

stationaere_abisoliermaschine

Wire dimension:

about 1 mm upwards

Wire cross section:

Round and rectangular

Stripping brushes:

See Consumables

Limit stop (length of stripping):

approx. 20 to 150 mm

Limit stopper for position of brushes (height of stripping):

2 pieces

Varnish coating:

blue/ yellow

Power supply:

400 V, 50 cycles

Order No.:

5.086.10

Extras:

Descripiton:

Order No.:

reversing switch

5.086.30

Dust extraction Equipment complete and mounted on the machine

5.086.40

Consumables (stripping brushes):

Outer ø

Width

Inner ø

Wire size

Order No.

80

40

16

0,20

5.084.63

80

40

16

0,25

5.084.64

80

40

16

0,30

5.084.65

80

40

16

0,35

5.084.66

80

40

16

0,40

5.084.67

80

40

16

0,50

5.084.68

logo_only

D U D E K
Fertigungssysteme
Im Dornschlag 6
77933 Lahr

Tel.: +49 (0) 7821/95 98 79
Fax: +49 (0) 7821/98 08 10
E-Mail:
info@karl-wetzel.de

Senden Sie E-Mail mit Fragen oder Kommentaren zu dieser Website an: webmaster@karl-wetzel.de
Copyright © 2013 D U D E K, Fertigungssysteme